Candy CD 571 S NORD User Manual download pdf (Page 51)

101

Identifying minor faults

Warning!

Before removing any panel: 1. Turn the knob to STOP.

2. Pull the electric plug out.

Should the dishwasher fail to operate, before contacting the Service Centre, make the

following checks:

FAULT CAUSE REMEDY

1 - Machine completely dead

2 - Machine does not

draw water

3 - Machine does not

discharge water

4 - Machine discharges water

continuously

5 - Spray arms are not heard

to rotate

6 - On electronic appliances

without a display: “eco”indi-

cator light and indicator light

“No.1” with audible signal

are heard.

7 -

On electronic appliances with

a display: “E1” appears on the

display with audible signal.

Plug is not connected to wall

socket

O/I button has not been pressed

Door is open

No electricity

See causes for no. 1

Water tap is turned off

Programme selector is not at

correct position

The inlet hose is bent

The inlet hose filter is not

correctly connected

Filter is dirty

Outlet hose is kinked

The outlet hose extension is

not correctly connected

The outlet connection on the

wall is pointing downwards not

upwards

Position of outlet hose is too

low

Excessive amount of detergent

Item prevents arms from rotating

Plate and cup filter very dirty

Water inlet tap turned off

Connect electric plug

Press button

Close door

Check the fuse in the plug and

the electricity supply

Check

Turn water tap on

Turn programme selector to

correct position

Eliminate the bends in the hose

Clean the filter at the end of the

hose

Clean filter

Straighten outlet hose

Follow the instructions for

connecting the outlet hose

carefully

Call a qualified technician

Lift outlet hose to at least 40 cm

above floor level

Reduce amount of detergent

Use suitable detergent

Check

Clean plate and cup filter

Switch off the appliance.

Turn on the tap.

Re-set the cycle.

Switch off the appliance.

Turn on the tap.

Re-set the cycle.

100

The water heater element is made of a special stainless steel which after a while may

change colour; this does not in any way affect its performance or its working life.

Both the door lining and the tank lining are in stainless steel; however, should spots

caused by oxidation occur, this is probably due to a high level of iron salts presents

in the water. The spots can be removed with a mild abrasive agent; never use

chlorine based materials, steel wool, etc.

WHEN CYCLE IS FINISHED

After every wash it is essential to turn off water supply and to switch off the machine

by pressing the On/Off button to the off position. If the machine is not going to be

used for some time, it is advisable to follow these rules:

1. do an empty wash with detergent in order to clean the machine of any deposits.

2. pull out the electric plug.

3. turn off the water tap.

4. fill the rinse aid container.

5. Ieave the door ajar.

6. Keep the inside of the machine clean.

7. If the machine is left in places where the temperature is below 0°C any water left

inside the pipes may freeze. Wait until the temperature rises above zero and then

wait for about 24 hours before starting up the dishwasher.

1 2 ... 46 47 48 49 50 51 52 53

Comments to this Manuals

No comments

Candy CD 571 S NORD User Manual Page 51

Comments to this Manuals

Related products and manuals for Dishwashers Candy CD 571 S NORD