Candy DSI 710 X UK User Manual download pdf (Page 14)

N.B.: Should any of the situations occur and should the machine give a bad washing performance,

it is necessary to remove the deposits from the dishes by hand since the final drying cycle hardens the

deposits which a second wash in the machine would not be able to remove.

If the malfunction continues contact a Service Centre quoting the serial number of the dishwasher.

This is found on the plaque on the inside of the dishwasher door at the top or on the guarantee.

This information will make it possible to take more effective action more quickly.

The manufacturers decline any responsability for any printing mistakes in this instruction booklet. They also reserve the right to modify their

own appliances as necessary without altering the essential characteristics.

FAULT CAUSE REMEDY

8 - Load of dishes is only

partially washed

9 - Presence of white spots

on dishes

10 -Noise during wash

11 - The dishes are not

completely dry

See causes for no. 5

Bottom of saucepans have not

been washed well

Edge of saucepans have not

been washed well

Spray arms are partially blocked

The dishes have not been

properly loaded

The end of the outlet hose is in

the water

The incorrect amount of

detergent has been measured

out; the detergent is old and hard

The wash programme is not

thorough enough

The lower basket dishes have

not been washed

Water is too hard

The dishes knock against one

another

The revolving arms knock against

the dishes

Inadequate air flow

Check

Burnt on food remains must

be soaked before putting pans

in dishwasher

Reposition saucepans

Remove spray arms by

unscrewing ring nuts clockwise

and wash under running water

Do not place the dishes too

closely together

The end of the outlet hose

must not come into contact

with the outflow water

Increase the measure

according to how dirty the

dishes are and change detergent

Choose a more vigorous

programme

Depress half load button

Check salt and rinse aid level

and regulate amount.

Should the fault persist,

Contact Service Centre

Load dishes better onto the

basket

Load dishes better

Leave the dishwasher door ajar

at the end of the wash program

to allow the dishes to dry naturally

Identifying minor faults

Warning!

Before removing any panel: 1. Turn the knob to STOP.

2. Pull the electric plug out.

Should the dishwasher fail to operate, before contacting the Service Centre, make the

following checks:

FAULT CAUSE REMEDY

1 - Machine completely dead

2 - Machine does not

draw water

3 - Machine does not

discharge water

4 - Machine discharges water

continuously

5 - Spray arms are not heard

to rotate

6 -

On electronic appliances

without a display: “eco”indicator

light and indicator light “No.1”

with audible signal are heard.

7 -

On electronic appliances with

a display: “E1” appears on the

display with audible signal.

Plug is not connected to wall

socket

O/I button has not been pressed

Door is open

No electricity

See causes for no. 1

Water tap is turned off

Programme selector is not at

correct position

The inlet hose is bent

The inlet hose filter is not

correctly connected

Filter is dirty

Outlet hose is kinked

The outlet hose extension is

not correctly connected

The outlet connection on the

wall is pointing downwards not

upwards

Position of outlet hose is too

low

Excessive amount of detergent

Item prevents arms from rotating

Plate and cup filter very dirty

Water inlet tap turned off

Connect electric plug

Press button

Close door

Check the fuse in the plug and

the electricity supply

Check

Turn water tap on

Turn programme selector to

correct position

Eliminate the bends in the hose

Clean the filter at the end of the

hose

Clean filter

Straighten outlet hose

Follow the instructions for

connecting the outlet hose

carefully

Call a qualified technician

Lift outlet hose to at least 40 cm

above floor level

Reduce amount of detergent

Use suitable detergent

Check

Clean plate and cup filter

Switch off the appliance.

Turn on the tap.

Re-set the cycle.

Switch off the appliance.

Turn on the tap.

Re-set the cycle.

1 2 ... 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

Candy DSI 710 X UK User Manual Page 14

Comments to this Manuals

Related products and manuals for Dishwashers Candy DSI 710 X UK