Candy PG46SQX User Manual download pdf (Page 21)

FOR U.K. ONLY

INSTRUCTIONS FOR THE INSTALLER

The following information is intended for qualified and competant persons only who will

ensure that your appliance is installed correctly. All current legislation concerning the in-

stallation of Gas appliances must be observed by the installer*

* For the U.K. only - By law, the gas installation/commissioning must be carried out by a

«Corgi», registered installer.

This appliance must be installed in accordance with applicable regulations and should only be

used in well-ventilated locations. Before using this appliance carefully study the instruction book.

Suitable location

A gas-powered cooking appliance produces heat and humidity in the area in which it is

installed. For this reason you should ensure good ventilation either by keeping all natu-

ral air passages open or by installing an extractor hood with an exhaust flue. Intensive

and prolonged use of the appliance may require extra ventilation, such the opening of a

window or an increase in speed of the electric fan, if you have one.

If a hood cannot be installed, an electric fan should be fitted to an outside wall or win-

dow as long there are air vents in the area.

The electric fan should be able to carry out a complete change of air in the kitchen 3-5

times every hour. The installer should follow the relavant national standards.

If a hob of 60 cm is fitted above an oven which is not equipped with fan cooling system

it is recommended that openings are created within the built in furniture to ensure cor-

rect air circulation.

The size of these openings must be at least 300 cm

and placed as shown in fig. 4.

When a 75 cm hob is fitted over a built in oven, the latter must be fan cooled.

FIG. 4

60 Cm

240 Cm

120 Cm

180 Cm

INSTRUCTIONS FOR THE INSTALLER

INSTALLATION

The Purchaser is responsible for the installation of the hob. The Manufacturer does not

accept any responsibility for any damage or loss resulting from incorrect installation,

and as such this will not covered by the Manufacturer’s Guarantee.

The hob may be installed in any worktop which is heat resistant to a temperature of

100° C, and has a thickness of 25 - 45 mm. The dimensions of the insert to be cut out

of the worktop are in shown in Fig. 1.

If the Hob is fitted next to a cabinet on either side, the distance between the Hob and the

cabinet must be at least 15 cm (see Fig. 2); while the distance between the hob and the

rear wall must be at least 5,5 cm.

The distance between the hob and any

other unit or appliance above it (e.g. An ex-

tractor hood) must be no less than 70 cm

(fig.2).

When there is an accessible space between

the built-in hob and the cavity below, a divi-

ding wall made of insulating material should

be inserted (wood or a similar material)

(fig.

3).

Important - The diagram below shows

how the sealant should be applied.

The Hob unit is fitted by attaching the Fixing

Clamps supplied, using the holes at the base of the unit.

Fig. 1

Fig. 2

Fig. 3

accessible space

GB IE GBIE

Plan 60 Plan 75

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 32 33

Comments to this Manuals

No comments

Candy PG46SQX User Manual Page 21

Comments to this Manuals

Related products and manuals for Stoves Candy PG46SQX