Candy P 700__1 SP CX User Manual download pdf (Page 17)

MAINTENANCE AND CLEANING

Important Advice

Before cleaning the Hob, ensure the appliance has cooled down. Remove the plug from

the socket or (if connected directly) switch off the electricity supply.

When cleaning the enamelled, varnished or chrome sections, use warm soapy water

or a non caustic detergent. For stainless steel use an appropriate cleaning solution.

Hotplates should only be cleaned with a cotton cloth coated with vaseline or seed oil.

Never use abrasives, corrosive detergents, bleaching agents or acids. Avoid any acid

or alkaline substances (lemon, juice, vinegar etc.) on the enamelled, varnisched or stain-

less steel sections.

The burners can be cleaned with soapy water. To restore their original shine, use a

household stainless steel cleaner. After cleaning, dry the burners and replace.

It is important the Burners are replaced correctly.

This appliance must only be used for the purpose for which it is intended, domestic

cooking, and any other use will be considered improper and could therefore be danger-

ous. The Manufacturer will not be responisble for any damage or loss resulting from

improper use.

Fig. 9

YES NO NO NO NO

Only pans which have smooth flat bases should be used on the electric hotplates. The

size of the pan should be as close as possible to the diameter of the hotplate, and ne-

ver smaller (see Fig. 9). The base of the pan should be dry and spillages should be

avoi-

ded. Empty pans should not be left on the plates, nor should the plates left switched

on without a pan.

THE GAS HOBS WITH ONE ELECTRIC

PLATE ARE FITTED WITH A PAN SUP-

PORT TO BE USED FOR RESTING PNA

WHEN THE PLATE IS NOT IN USE.

WHEN THE HOTPLATE IS SWITCHED

ON THE PAN SUPPORT MUST BE LIF-

TED UP TO ALLOW THE PAN TO BE

PLACED IN DIRECT CONTACT WITH

THE HOTPLATE.

Fig. 10

Lubricating the gas taps

If a gas tap becomes stiff, it should be dismantled, cleaned carefully with petrol and

smeared with a drop of special heat resistant grease.

The following operations should be carried but:

— disconnect the electrical power supply, close the gas supply tap from the mains or

cylinder.

— Remove the hob top plate by removing the corner screws and those under the

burners.

— Remove the two screws holding down the head flange.

— Remove the head flange and the retaining spring on the knob shaft.

— Remove the gas regulation cone, clean it with petrol and smear it with some heat

resistant grease, taking care not to obstruct any holes through which gas must pass.

— Re-assemble all the parts, making sure that the spring and the rotating axis of the

cone fitted to the knob shaft are correctly seated.

Aftercare

Before calling out a Service Engineer please check the following:

— that the plug is correctly inserted and fused;

— that the gas supply is not faulty.

If the fault cannot be identified:

switch off the appliance — do not tamper with it — call the Aftercare Service Centre.

The appliance is covered by a 12 month Guarantee giving free Aftercare Service.

The Manufacturer will not be responsible for any inaccuracy resulting from printing or transcript errors con-

tained in this brochure. We reserve the right to carry out modifications to products as required, including

the interests of consumption, without prejiudice to the characteristics relating to safety or function.

1 2 ... 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Candy P 700__1 SP CX User Manual Page 17

Comments to this Manuals

Related products and manuals for Stoves Candy P 700__1 SP CX