Candy MULTIPURPOSE BUILT-IN HOBS Instruction Manual download pdf (Page 17)

Overheat control for induction cooking zones

In principle, the induction works intrinsically safe. The induction electronics provide temperature sensors at each

cooking zone being located below the glass ceramic surface to monitor temperatures. Further temperature

sensors along the heat sink protect the electronics itself against overheating. The software may reduce the power

or switch off all cooking zones in case of too high measured temperature values.

Pause Function (CDI32B)

When at least one cooking zone is in operation, the heating elements may be switched off by actuating the

special key “pause” for >= 1s. Already programmed times (also egg timer) are

stopped

and do

not

continue

during the pause. Automatic heat-up and booster are also switched off on all cooking zones during activation,

the residual heat calculation and operating time limitation continue and are not stopped. The pause condition

may last for max. 10 minutes. If the status is not terminated within this time, the control switches off. The cooking

zone may be switched at any time with the on/off key – a possibly activated pause mode is then terminated.

In order to terminate the pause mode and put into operation again the cooking zones, the special function

key and any other key (not the same again) has to be actuated within 10 seconds.

Recall Function

By using of the recall function the settings may be recovered quickly, when the control had been switched off

with the main switch by mistake. After switching off the power key the operator has 6s to switch on again the

control and another 6s to actuate the pause key. The pause mode is not possible within the first 6s after

switching on. The execution of the function is only possible, if at least one cooking zone was active (cooking

stage > 0), independent from the key-lock status and is confirmed with an acoustic key signal.

The following is re-established:

Cooking stages of all cooking zones

Minutes and seconds of programmed cooking zone-related timers

Switching condition of the outer circuits (is guaranteed by outer-circuit memo function)

Heat up function and booster

Booster function (CDI32B)

After the selection of a desired cooking zone, the boost function can be selected bringing

the zone power to the maximum level and then pressing the increase button again.

If the desired cooking zone has the capacity to receive this power, the display shows a “P” symbol.

In case the power is not permitted the cooking stage display flashes for 3 sec on the cooking zone which needs

to be reduced and which requires automatic adjustment. The boosting time is limited to 10 min. After the booster

is switched off automatically, the cooking zone continues operation on nominal power. The booster can be

reactivated provided that the temperature sensors in the electronics and in the coils have the capacity.

In case that the pan is removed from the cooking zone during boosting, the boosting function remains active and

boosting time continues. If the booster temperature limit of the electronics or the coil of a boosted cooking zone

is exceeded, the booster is cut off automatically and reset to nominal power.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

No comments

Candy MULTIPURPOSE BUILT-IN HOBS Instruction Manual Page 17