Candy BMC 60 X User Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
To connect the coffee machine power cord, loosen and remove the cover on the terminal block in order to
access the contacts inside. Make the connection, blocking the cord in place with the cable clamp provided and
then close the terminal block cover again immediately.
If you have to change the cord, the length of the conductors between the cord anchorage and the terminals,
shall be such that the current-carrying conductors become taught before the earthing conductor if the cord slip
out of the cord anchorage.
Fixing the Coffee machine to the unit (fig. C,D – pag.3)
Mark on the piece of furniture the measure for the positioning of the blocking supports.
Fix to the piece of furniture the blocking supports, paying attention to place the nut cages [1] as shown in the
picture C.
Place the coffee machine on the piece of kitchen furniture so to be installed
The holes of the blocking screws are: Inside the area of the water reservoir, on the right as shown.(fig.D).
Fix the coffee machine with the screws and the allen key given. (Fig A8).
5. INSTRUCTIONS FOR FIRST USE
Filling the water reservoir (fig. E –pag.3)
Push the reservoir door (Fig A18), which will open on the right hand side
Remove reservoir from cabinet (Fig A19)
Fill up reservoir with fresh water and place back in the cabinet, shut door (Fig A18)
Ensure that the filter (Fig A10) has been placed in cold water for a few minutes prior to first use.
If the coffee machine has not been used for long periods of time, change the water in the reservoir.
Starting the Coffee Machine
Switch the coffee machine on by pressing the Main switch 0/I (Fig A16)
The green light [B1] will illuminate. At the same time the coffee boiler green light [B2] will flash indicating the
coffee boiler is heating up.
Please note that the red light [B5] will turn on when the water reservoir is empty
The machine is ready for use when this green light [B2] stops flashing and remains on.
6. COFFEE DISPENSING
The coffee dispensing can be activated in “MANUAL” or “PROGRAMMED” setting by using the Push-button [B6] as
follows:
MANUAL” coffee dispensing setting: If the button [B6] is held down (for less than one second), the machine
will dispense coffee. Press the button [B6] again to stop dispensing.
PROGRAMMED” coffee dispensing setting. This allows you to memorise a duration for coffee dispensing
which could be call back in every moment:
programming duration for coffee dispensing: hold on the push button [B6] for more that 5 seconds.
Keeping the button [B6] pressed the appliance will memorise the time for coffee dispensing for as long
as the button is held down.
When the desired time is reached release the button [B6] and immediately press it twice.
It is possible to memorise a duration of coffee dispensing once. Repeating the operation will erase the
memory already set.
Using the coffee dispensing with programmed duration: In order to use the programmed time hold
down the button [B6] for more than one second but less than five.
After that the button [B6] has been released the machine will dispense coffee for the length of time
programmed.
7. STEAM PUSH-BUTTON
Press the button [B7] to turn on the steam boiler
The green light [B3] will flash to indicate the machine is heating up.
The machine is ready for use when this green light [B3] stops flashing and remains on.
In order to heat a liquid (i.e. milk, the .) with the steam pipe use a suited metallic kettle long and tight with an
handle.
o In the meantime the appliance is releasing steam it is advisable to move slowly the kettle from up and down in
order to mix the liquid while it is heating up.
o Check that the pipe is been always immersed into the kettle.
o It is necessary to rotate the steam pipe out of the appliance and perform thae operation described above,
paying attention to keep hold the kettle
o At the end of steam releasing move the pipe over the drip tray and let it trickle
The coffee dispensing can be activated in “MANUAL” or “PROGRAMMED” setting by using the Push-button [B8] as
follows:
MANUAL” coffee dispensing setting: If the button [B8] is held down (for less than one second), the machine
will dispense coffee. Press the button [B8] again to stop dispensing.
13
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments